Do you require more precise control when filling smaller candle molds? Use our Ball Valve reducer to reduce the size of flow. It's easy to connect right onto the Large 1.5" Ball Valve your wax melting tank comes supplied with.
You can save considerable time when using this reducer. Instead of pouring your wax into a smaller vessel before filling your candle mold, now you can dispense directly from the wax melter tank.
Reduces flow down to 3/8" (10mm) by connecting directly onto the 1.5" (38mm) Ball Valve. You then use the Reducer for turning flow on and off.
Reduces from the 1.5" (38mm) Ball Valve to a smaller 1/2" (13mm) Ball Valve with 3/8" (10mm) flow.
Fully assembled and Ready to install! You do not need pipe cement or Teflon tape when attaching to the 1.5" Ball Valve.
Suitable for temperatures up to 220 F (104 C).
Withstands most acids and alkalis.
Instructions to use Ball Valve Reducer:
1st step - Ensure the reducer valve is in closed position before installing.
Thread the reducer into the large ball valve. Its only necessary to be hand tight. Its easy to remove too.
Plastic to plastic makes a superior seal without the need for Teflon tape. It does not need to be extremely tight.
Open the large 1.5" ball valve and then dispense with the small ball valve on the reducer.
When you are finished dispensing, Close the Big Valve and unscrew the reducer to remove.
Really simple to clean - Run a twisted up piece of rag or dowel rod through the opened ball valve in the reducer to clean most of your product out and then just wash and you're ready to run your next batch.